Husqvarna 230 ACX - Manual (Page 70)

English - 71
8. MAINTENANCE
8.6 Replacing the blades
There are three blades on Automower™, which are
screwed into the blade disc. The blades have four
edges (two edges for 220 AC) to ensure a longer
service life. Two of the edges are equally worn as the
blade disc rotates alternately to the left and
alternately to the right. When the edges (1 and 2)
have become dull, loosen the screw and turn the
knife over so that edges 3 and 4 are facing outwards.
All three blades and screws must be replaced at the
same time to obtain a balanced mowing system.
There are two blade variants with different
characteristics to choose from as accessories. Contact
your dealer for further information.
To replace the blades:
1. Set the main switch to the OFF position.
2. Wear protective gloves.
3. Turn Automower™ upside down.
4. Rotate the skid plate so that its hole aligns with
the screw for the blade.
5. Unscrew the blade. Use a straight slot or
cross-tip screwdriver.
6. Pry apart the skid plate and blade disc a little and
remove the blade and screw.
7. Screw tight the new blade.
WARNING
Always use original blades and
screws when replacing.
Only replacing the blades and
reusing the screw can result in the
screw wearing during mowing and
shearing off. The blades can then be
thrown out and cause serious injury.
1
2
3
4