gohastings.com POWERPOD 400 - Manual (Page 19)

Page 19 of 42
10.1. ENTERING THE SETUP/CAL MODE
Pressing the MODE key causes the MODE menu to be displayed. Choose the SETUP/CAL mode by
pressing the number “3” key then ENTER. A CHANNEL SELECT menu is presented on the display.
It should be noted that, although the user must select a specific channel number, some choices in the
following menus may affect the operation of all channels and/or the display (ex; Display Brightness, type of
communication). See the following menu options for more details.
10.2. DISPLAY SETUP
After entering the SETUP/CAL mode and selecting a channel number as described in the previous
section, several selections are available that will affect the display. Follow the steps below to gain the
desired customized display.
10.2.1. Blanking a Display Line/Channel
Use the serial command “DndCr”, where
n = channel number,
d = 1 for Totalizer Mode,
2 for Meter Mode,
3 for a blanked line and
Cr = carriage return.
10.2.2. Selecting Display Brightness
While the SETUP/CAL menu is displayed, choose DISPLAY by pressing the keys “1” + ENTER.
Choose BRIGHTNESS by pressing the number “1” key + ENTER. The BRIGHTNESS menu will be
visible. One of four different brightness levels can be chosen by pressing a number key. The number “1”
key selects the dimmest setting while the number “4” key selects the brightest. Any change in brightness
will affect the entire display after pressing the ENTER key.
10.0 Setup/Cal Mode
Note: Front panel lockout and display line (channel) blanking are only available
through serial communication.