gohastings.com POWERPOD 400 - Manual (Page 5)

Page 5 of 42
Important – The Power
Pod
-400 comes calibrated from the factory according to your specifications.
No set up is necessary unless you need to change the specs
1.0 Quick Start Instructions
1ea Power
Pod -400
1ea AC power cord
1ea 15-pin, Hi Density, D-style connector
1ea 9-pin, D-style connector
1ea user’s manual
When unpacking the Power Pod , the package will contain
everything you need.
Connect a “known good” transducer to the desired
channel (See next frame for pin-outs)
J-1 Ch1 5 Signal common
J-2 Ch2 6 Analog signal
J-3 Ch3 7 Case ground
J-4 Ch4 8 Override Control
J-5 Analog out 9 -15 VDC
J-6 RS-232 10 NC
J-7 RS-485 11 +15 VDC
J-8 Alarms 12 Valve return
J-9 RS-485 14 Set point (in)
Pin-outs
1) Check power setting switch on the back panel
and make sure it is set appropriately.
2) Ensure the power switch is off, and then connect
the power cord.
CLOSE
HASTINGS
OPEN
OPEN
CLOSE
OPEN
CLOSE
OPEN
CLOSE 1
4
3
2
7
1
4
0
9
3
6
8
2
5
.
Turn power switch to on position. If you have just
turned on the mass flow instrument and the power,
some settling is necessary.
1) Press the desired Channel # Key. Press the Auto
key.
(For Controllers)
2) Press the desired Channel # Key. Enter desired
flow. Press the enter key.