HONDA MM60 User Manual
Page 15
SET-UP AND
ASSEMBLY
Installing
Lift
Rods
(For
Tractors Without Rear Three Point Hitch)
1.
Adjust the lift rod to 365 mm
(1
4.4
in) measured
from
eye to eye as illustrated. Adjustment is
made by turning barrel
of
rod, then secured by
tightening nut. Be sure that an equal length
of
threads shows on either end ,of barrel.
I
I
365 mm
14.4
in.
I
I
I
(with loader subframe)
I
375
mm
14.8
in.
2.
Slide eye
of
lift rod over pin on tractor lift arm.
Position clevis
of
lift
rod between brackets on lift
link. Note that outside leg
of
lift
rod goes out-
side of lift link as illustrated. Install with greased
22
x
76
mm clevis pin with head on left side as
shown. Secure both ends with
22
rnrn
washers
and linchpins.
NOTE: The eye
of
the lift rod is not straight. The
curve should point to the inside of the tractor
when properly installed.
i 3