HONDA MM60 User Manual
Page 37
INSTALLING MOWER
Using Rear Three Point Hitch with Mower
Detached While the Mower Lift Linkage is
Still Installed
1 Detach mower as described below.
2.
Start engine and set Lift Control Lever on "UP"
to raise lift arms to maximum position. Turn
off
engine, turn Lowering Speed Control fully
clockwise to lock hydraulic system and set
brakes.
NOTE: Block the
lift
plate to its full UP position.
3.
Pull pin from projecting bracket at top of left
hand
lift
rod, and remove as illustrated to
release
lift
chain. Hold chain
so
that it does not
fall.
4.
Attach
lift
chain to projecting chain rest pin on
the
Roll
Over Protection System. Secure with
washer and cotter pin. MAKE SURE TO
RE-
TAIN CLEVIS PIN IN SAFE PLACE
TO
BE ABLE
TO RE-ATTACH CHAIN
ROD.
5.
Install attachment as needed.
35