HONDA MM60 - Manual (Page 47)

MAINTENANCE
Blade Spindle Assembly
1. Bearing cups and cones are designed to work
together. It is important to position them so
bearing cone taper mates with bearing cup
taper.
2. Lubricate new cups with a light oil. Place them
in spindle housing so they will mate with cones.
Seat cups against machined shoulder of hous-
ing with a press or by placing a large drift on the
flat lip and driving them into housing.
3. Place bottom bearing cone onto spindle shaft
with taper up. Seat on bottom shoulder of shaft
with a press.
4. Insert shaft and bearing cone assembly through
bottom of
housing cavity with a
lithium grease of consistency with a MOLY
(molybdenum disulfide) additive.
5. Place top bearing cone on shaft to mate with
top bearing cup.
Bearing adjustment is set by
pressing sleeve against bearing cone until
proper adjustment
is attained.
6. Install sleeve on shaft and press sleeve and
bearing cone onto shaft until all bearing free
play is removed and there is a slight drag
(similar to adjusting the front wheel bearings on
an automobile). Check by spinning spindle. It
should turn freely.
6. Be careful not to over-tighten bearings. Proper
bearing adjustment
is essential to good bearing
life.
7. Should you over-tighten bearings, hold spindle
housing and rap spindle shaft with a lead
hammer to loosen bearings. Readjust bearings
until proper setting is obtained.
Improper positioning of seals
can cause seal failure.
8. Proper seal installation is important. An improp-
erly installed seal will leak and could cause
bearing failure.
the rubber portion of seal back and locate.
spring.
.
i
I
J
Seal
3. Sleeve
4. Bearing cone
5. Housing and cups
6. Cup
7. Shaft
Spindle Assembly
I
45