HONDA MM60 - Manual (Page 56)

TROUBLESHOOTING
PROBLEM SOLUTION
1. Tractor speed too fast to lower gear.
2. Grass accumulation inside deck 2. Clean deck underside.
3. Dull Blade 3. Have the blade sharpened or replace it.
Tires improperty inflated 4. Check the tire inflation.
5. Mower not level 5. Check the blade height.
6. Wrong mower deck height 6. Change to proper height.
7. Engine speed too low 7. Run at full throttle.
1. 'Blade driie belt worn or broken
2. Mid PTO not selected
3. Faulty PTO clutch or worn disk
Replace with new belt.
2. Check PTO Selector Lever position
3. See your authorized HONDA Multi-purpose
Tractor dealer.
Wrong blade
2. Deck too low
3. Engine overloaded
Lawn wet or watered
5. Lawn too tall
6. Engine speed too low
1. Use genuine HONDA blade or equivalent.
2. Raise deck and adjust deck height properly..
3. Operate at full throttle. Use lower speed range.
Set mower deck higher than ,desired height for
first pass, then cut to desired height on second
pass.
Allow to dry before cutting.
5. Set mower deck higher than desired height for
first pass, then cut to desired height on second
pass.
on Mid-PTO.)
6. Run at f u l l throttle. (Do not exceed rpms
1. Cutting height too low 1. Increase to proper height.
2. Tractor speed too high
,
2. Lower to proper speed.
3. Uneven surface 3. Change cutting pattern.
4. Rough and uneven surface 4. Adjust with height adjuster.
Unbalanced blades 1. Adjust balance.
2. belt damaged 2. Replace.
3. damaged or out of alignment 3. See your authorized HONDA multi-purpose
4. Lack of gearbox lubricant 4. Lubricate with SAE 90 weight gear lubricant
tractor dealer.
1. Engine speed too low 1. Run at full throttle. (Do not exceed 2400 rpms
2. Tractor speed too fast 2. Lower to proper speed range.
3. Pebbles or other foreign matter are stuck 3. Remove.
on Mid-PTO.)
in mower deck
54