HONDA MM60 - Manual (Page 23)

INSTALLING MOWER
Attaching Front Mower Links To Mower
1. Screw the adjustable plate link onto the right
and left front mower links. Adjust the plate link
as
shown in illustration, so that the straight line
length is 450 mm (17.75 in). Face the plate link
to the outside as shown and insert into the
projecting brackets on the mower deck
.
2. Install both right and left links. Secure with 16
mm greased clevis pin inserting pin from out-
side. Insert linchpin to lock.
Front Mower Links
INSTALLING MOWER TO TRACTOR
1. Adjust gauge wheels to lowest cutting position.
2. Chock right and left front wheels as shown.
3. Start the tractor and keep engine at low idling
speed. Set the lift control lever to the "UP"
position and keep the lift arm up.
Drive front wheels over the flat
area of the pulley covers only! Avoid run-
ning over gear box, drive shaft and rear links
to prevent damaging them.
Front Wheels Chocked
2 1