HP 220 - Manual (Page 2)

For HP Internal Use
:nly
R Copyright HewlettĆ
Packard Company 1994
This document contains
proprietary information
that is protected by
copyright. All rights are
reserved. No part of this
document may be
photocopied, reproduced,
or translated into another
language without the prior
written consent of HewlettĆ
Packard Company.
HP internal order number
C3187Ć90000
Second edition, September
1994
Printed in France
Warranty
The information contained
in this document is subject
to change without notice.
HewlettĆPackard makes
no warranty of any kind
with regard to this
material, including, but
not limited to, the
implied warranties of
merchantability and
fitness for a particular
purpose.
HewlettĆPackard shall not
be liable for errors
contained herein or for
incidental or consequential
damages in connection
with the furnishing,
performance, or use of this
material.
WARNING
The procedures described
in this manual are to be
performed by HPĆqualified
service personnel only.
Electrical Shock
Hazard
Serious shock hazard
leading to death or injury
may result if you do not
take the following
precautions:
D Ensure that the ac power
outlet (mains) has a
protective earth (ground)
terminal.
D Disconnect the plotter
from the power source
prior to performing any
maintenance.
D Prevent water or other
liquids from running
onto electrical
components or circuits,
or through openings in
the enclosure.
Electrostatic Discharge
Refer to the beginning of
Chapter 6 of this manual,
for precautions you should
take to prevent damage to
the plotter circuits from
electrostatic discharge.
Safety Symbols
General definitions of
safety symbols are given
immediately after the table
of contents.
Learning Products, Barcelona Division
HewlettĆPackard Española, S.A.
Avda. Graells, 501
08190 Sant Cugat del Vallès
Spain