HP 220 - Manual (Page 69)

1 Ensure that the plotter is switched off
and that the power cord and interface
cable(s) are not connected to it.
2 At the back of the plotter, ensure that
the two small wire clamps of the parallel
port are positioned vertically.
No interface
cables connected.
Power inlet: cord
not connected
3 Remove the screws that attach the
electronicsĆenclosure cover to the
electronics enclosure.
zH H ha H c H
zH H ha H H c H
4 Gently lift open the electronicsĆenclosure
cover to an angle of 45 d .
Torx-20 or Flat
6Ć5 Removal and Replacement C3187Ć90000
Repair Procedures
Removing the ElectronicsĆEnclosure Cover