HP EXPANSION BASE 344524-001 - Manual (Page 45)

5–16 Maintenance and Service Guide
Removal and Replacement Procedures
5.9 Back Panel
1. Prepare the Expansion Base for disassembly (Section 5.3) .
2. Remove the base plate (Section 5.4) .
3. Remove the upper chassis (Section 5.5) .
4. Remove the front tray cover (Section 5.8) .
5. Position the upper chassis right-side up with the speakers
facing you.
✎
Make sure that the back panel is supported before performing the
following steps.
6. Remove the four PM2.0×4.0 screws 1 that secure the back
panel to the chassis.
7. Remove the back panel with the RJ-11 cable attached 2.
Removing the back panel
Reverse the above procedure to install the back panel.
Spare Part Number Information
Back panel with RJ-11 cable 347433-001