HP EXPANSION BASE 344524-001 - Manual (Page 46)

Removal and Replacement Procedures
Maintenance and Service Guide 5–17
5.10 Expansion Cable
1. Prepare the Expansion Base for disassembly (Section 5.3) .
2. Remove the base plate (Section 5.4) .
3. Remove the upper chassis (Section 5.5) .
4. Remove the front tray cover (Section 5.8) .
5. Remove the back panel (Section 5.9) .
6. Turn the upper chassis right-side up with the rear facing you.
Rotate the chassis so that the expansion cable connector is
facing away from you.
7. Remove the four PM2.0×2.0 screws 1 that secure the
expansion cable clamps to the chassis.
8. Remove the expansion cable clamps 2 and the
expansion cable 3.
Removing the expansion cable clamps and expansion cable
Reverse the above procedure to install the expansion cable.
Spare Part Number Information
Expansion cable 347435-001