Honeywell HCE 60 - Manual (Page 31)

Start-up
29
Operating modes of storey controller
Normal mode
In normal mode, LEDs 1 through 8 provide information on the posi-
tion of the actuators:
Green Thermal actuator opened
Off Thermal actuator closed
Fault mode
In fault mode, the status displays provide information on a fault in
the individual temperature zones.
Refer to section
"Displaying faults" on Page 42.
Installation mode
In installation mode, temperature zones are assigned to the set-
point adjusters and the Hometronic Manager.
Refer to section "Assigning zones and issuing room names" on
Page 32.
Device display
The device display informs you of the configuration of your Home-
tronic system: i.e. the assignment of setpoint adjusters to a tem-
perature zone of room names at the Hometronic Manager.
Refer to section "Checking configuration" on Page 40.