Honeywell HCE 60 - Manual (Page 40)

Assigning zones and issuing room names
38
► Press Installation button .
The LED of zone 1 flashes green.
► Assign room names for heating.
► Press Installation button .
The LED of zone 1 flashes green/orange.
► Assign room names for cooling.
► Repeat these steps until 2 room names are assigned to all tem-
perature zones.
Canceling assignment
Canceling assignment of setpoint adjuster to a temperature zone
► Press and hold Installation button at least 2 seconds.
The LED illuminates. The LED of zone 1 flashes red.
► Press Installation button repeatedly until the LED of the zone to be
removed flashes red.
► Press Fault button until the LED of the temperature zone goes
out.
The assignment of the setpoint adjuster to the temperature zone
has been canceled.