HONDA FL5540K0 - Manual (Page 28)

OPERATIONAL CHECK
OPERATING TIPS
NOTICE-Do not use the bucket for pushing
down material with bucket cylinders partially
extended. Cylinder and rod may be
damaged.
Do not tip bucket cutting edge down (fully
extend bucket cylinders) during
operation. Cylinder
and rod may be damaged.
Position vehicles to be loaded as near the pile
as possible and in such a direction as to
minimize the amount of tractor turning
required to dump.
Do not use the spill guard to push objects as
it will deform and become damaged.
Keep the unit clean and perform regular
service. Observe safety instructions
whenever cleaning,
lubricating.
We urge you to follow this advice:
1.
2.
3.
4.
5.
Read and understand this manual as well
as the tractor owner’s manual.
Remember and observe the Safety
Precautions brought to your attention in
this manual, the tractor manual and on the
loader itself.
Use good common sense in the everyday
operation of this unit, Safety instructions
can never be all inclusive. You are
responsible for watching out for, and
avoiding, unsafe conditions.
Never exceed the limits of a piece of
machinery. If its ability to do a job or to do
so safely is in question-Don’t try it.
Don’t hurry the learning process or take
the unit for granted. Ease into it and
become familiar with your new loader and
tractor.
6. When lowering a heavy load, ease it
downward slowly. Never drop a loaded
bucket and “catch” hydraulically.
Stopping a load after
it has gained
downward momentum places undue
strain on the unit and may cause damage
to the loader or tractor.
- Before disconnecting
hydraullc lines, relieve all pressure.
Escaping hydraulic oil under pressure can
have sufficient force to penetrate the skin
causing serious personal injury.
If Injured by
hydraulic oil, consult a
Immediately.
-Do not operate the loader if
the hydraulic fittings or hoses are leaking or
damaged. A sudden line burst can cause the
main frame to drop suddenly, causing damage
to the tractor or loader or injury to personnel.
BEFORE OPERATING, LUBRICATE ALL
MOVING PARTS. (Refer to lubrication section)
COLD WEATHER OPERATION
To assure smooth operation in cold weather,
allow the tractor to warm up. Slowly cycle the
loader and bucket several times to warm the
fluid in the hydraulic system. The loader may
operate erratically until the hydraulic fluid has
warmed to operating temperatures.
26