Heat & Glo Fireplace AUSTRALIAN GAS ASSOCIATION DAKOTA-AU - Manual (Page 10)

10 Heat & Glo Lifestyle Collection • Dakota-AU• 4036-914 Rev B • 06/07
Battery polarity must be correct or module damage will
occur.
CAUTION
6 6
Electrical Information
Label all wires prior to disconnection when servicing
controls. Wiring errors can cause improper and dangerous
operation. Verify proper operation after servicing.
CAUTION
BATTERY PORT
(4 AA BATTERIES)
VALVE
PILOT
IGNITION MODULE
6VDC
ON/OFF
SWITCH
THERMOCOUPLE
BLOCK
(CONNECTED TO
BACK OF VALVE)
PILOT GAS LINE
CONNECTED TO
BACK OF VALVE
IGNITION
MODULE
(6V)
ON/OFF
WALL SWITCH
VALVE
FLAME SPARKER/
SENSOR
ANT.
REMOTE
CONTROL
A. Ignition System Wiring
• This fi replace is equipped with an electronic ignition
system which operates on a 6 volt system.
• The batteries are located within the ignition module which
is located within the external control box. A wiring diagram
is shown in Figure 6.1.
• The battery pack requires four AA batteries (not included).
See Section 10.B. for battery replacement.
Figure 6.1 Electronic Ignition Wiring Diagram
B. Remote Control
• This fi replace is equipped with a remote control to
operate the ignition system.
• 9 volt battery required.
• Follow operating instructions included with remote
control.