Heat & Glo Fireplace AUSTRALIAN GAS ASSOCIATION DAKOTA-AU - Manual (Page 5)

Heat & Glo Lifestyle Collection • Dakota-AU• 4036-914 Rev B • 06/07 5
A
E
Note: If this surface is
inside the building’s
warm air envelope...
...then this surface
must be an exterior
wall system.
B
C
D D
B
C
E
D
1.47 M
2.08 M
Note:
• Illustrations refl ect typical installations and are FOR
DESIGN PURPOSES ONLY.
• Illustrations/diagrams are not drawn to scale.
• Actual installation may vary due to individual design
preference.
Fire Risk
Provide adequate clearance:
• Around air openings.
• To
combustibles.
• For service access.
Locate fi replace away from traffi c areas.
WARNING
A. Select Fireplace Location
When selecting a location for your fi replace it is important to consider the required clearances to walls (See Figure 3.1).
Note: For actual f ireplace
dimensions refer to Section 12.
Figure 3.1 Fireplace Locations
3 3
Framing and Clearances
A B C D E
629 mm 1.22 m 1.25 m 13 mm 38 mm
This appliance shall be used in an above ground open-air situation with natural ventilation,
without stagnant areas, where gas leakage and products of combustion are rapidly
dispersed by wind and natural convection.