HP 3500 User Manual
Page 156
Control panel message
Description
Recommended action
REPLACE TRANSFER KIT
alternates with
To continue press
The transfer unit is near end of life and
the SUPPLIES LOW setting in SYSTEM
SETUP is set to STOP.
1.
Order the transfer kit.
2.
Press
to continue printing.
See
for more
information.
Request accepted
please wait
The printer has accepted a request to
print an internal page, but the current
job must finish printing before the
internal page will print.
No action necessary.
Resend
upgrade
The firmware upgrade was not
completed successfully.
Attempt upgrade again. You might need
to use the parallel port to send the
upgrade file.
Restoring
factory settings
The printer is restoring factory settings.
No action necessary.
Restoring...
The printer is restoring settings.
No action necessary.
Resetting Kit Count
YES was selected in the RESET
SUPPLIES menu to reset the counts for
any of the supplies that cannot be
detected as new.
No action necessary.
Rotating <COLOR>
motor
alternates with
To exit press
STOP key
A component test is in progress; the
component selected is <color>
Cartridge motor.
Press
S
TOP
when ready to stop this test.
Rotating motor
alternates with
To exit press
STOP key
The printer is executing a Component
Test and the component selected is
Rotating <COLOR>.
Press
S
TOP
when ready to stop this test.
Setting saved
A menu selection has been saved.
No action necessary.
Tray X
<TYPE> <SIZE>
alternates with
To change size or
type press
The printer is reporting the current
configuration of Tray X.
No action necessary.
See
for more details.
UNAUTHORIZED SUPPLY
IN USE
alternates with
Ready
The printer has detected that a non-HP
supply is currently installed and
(override) was pressed.
If you believe you purchased an
HP supply, please call the HP fraud
hotline at 1-877-219-3183.
Service or repairs required as a result of
using non-HP supplies are not covered
under HP warranty.
144
Chapter 8 Problemsolving
ENWW