HP 3500 User Manual
Page 67
14. Press
to select MANUAL SETTINGS.
15. Press
to highlight DEFAULT GATEWAY.
16. Press
to select DEFAULT GATEWAY.
Note
The first of four sets of numbers are the default settings. Each set of numbers represents
one byte of information and has a range from 0 to 255.
17. Press the
or
arrow to increase or decrease the number for the first byte of the
default gateway.
18. Press
to move to the next set of numbers. (Press
to move to the previous set of
numbers.)
19. Repeat steps 17 and 18 until the correct subnet mask is entered.
20. Press
to save the default gateway.
21. Press
M
ENU
to return to the Ready state.
Setting the syslog server
1. Press
M
ENU
to enter the MENUS.
2. Press
to highlight Configure Device.
3. Press
to select Configure Device.
4. Press
to highlight I/O.
5. Press
to select I/O.
6. Press
to highlight EIO 1.
7. Press
to select EIO 1.
8. Press
to highlight TCP/IP.
9. Press
to select TCP/IP.
10. Press
to select CONFIG METHOD.
11. Press
to highlight MANUAL.
12. Press
to select MANUAL.
13. Press
to highlight MANUAL SETTINGS.
14. Press
to select MANUAL SETTINGS.
15. Press
to highlight SYSLOG SERVER.
16. Press
to select SYSLOG SERVER.
Note
The first of four sets of numbers are the default settings. Each set of numbers represents
one byte of information and has a range from 0 to 255.
17. Press the
or
arrow to increase or decrease the number for the first byte of the
default gateway.
18. Press
to move to the next set of numbers. (Press
to move to the previous set of
numbers.)
19. Repeat steps 17 and 18 until the correct subnet mask is entered.
ENWW
Network configuration
55