HP 3500 User Manual
Page 65
12. Press
to save the setting.
13. Press
M
ENU
to return to the Ready state.
Manually configuring TCP/IP parameters from the printer control panel
Use manual configuration to set an IP address, subnet mask, default gateway, syslog
server, and idle timeout.
Setting an IP address
1. Press
M
ENU
to enter the MENUS.
2. Press
to highlight Configure Device.
3. Press
to select Configure Device.
4. Press
to highlight I/O.
5. Press
to select I/O.
6. Press
to highlight EIO 1.
7. Press
to select EIO 1.
8. Press
to highlight TCP/IP.
9. Press
to select TCP/IP.
10. Press
to select CONFIG METHOD.
11. Press
to highlight MANUAL.
12. Press
to select MANUAL.
13. Press
to highlight MANUAL SETTINGS.
14. Press
to select MANUAL SETTINGS.
15. Press
to highlight IP Address:.
16. Press
to select IP Address:.
Note
The first of four sets of numbers is highlighted. Each set of numbers represents one byte of
information and has a range from 0 to 255.
17. Press the
or
arrow to increase or decrease the number for the first byte of the IP
address.
Note
To cycle through the numbers faster, hold down the arrow button.
18. Press
to move to the next set of numbers. (Press
to move to the previous set of
numbers.)
19. Repeat steps 17 and 18 until the correct IP address is entered.
20. Press
to save the setting.
21. Press
M
ENU
to return to the Ready state.
Setting the subnet mask
1. Press
M
ENU
to enter the MENUS.
2. Press
to highlight Configure Device.
ENWW
Network configuration
53