HP 3500 - Manual (Page 56)

9. Press to set the selection.
10. Press M
ENU
.
Supplies low
The printer allows two options for reporting that supplies are low; CONTINUE is the default
value.
● CONTINUE allows the printer to continue printing while displaying a warning until the
supply is replaced or a supply out condition is reached.
● STOP causes the printer to pause printing until you replace the used supply or press ,
which allows the printer to print while continuing to display the warning.
To set supplies low reporting
1. Press M
ENU
to enter the MENUS.
2. Press to highlight Configure Device.
3. Press to select Configure Device.
4. Press to highlight SYSTEM SETUP.
5. Press to select SYSTEM SETUP.
6. Press to highlight SUPPLIES LOW.
7. Press to select SUPPLIES LOW.
8. Press or to select the appropriate setting.
9. Press to set the selection.
10. Press M
ENU
.
Jam recovery
This option allows you to configure the printer response to paper jams, including how it
handles the pages involved. AUTO is the default value.
● AUTO. The printer automatically turns jam recovery on when sufficient memory is
available.
● ON. The printer reprints any page involved in a paper jam. Additional memory is
allocated to store the last few pages printed. This might cause overall printer
performance to suffer.
● OFF. The printer will not reprint any page that was involved in a paper jam. Since no
memory is used to store the most recent pages, performance might be optimal.
To set jam recovery response
1. Press M
ENU
to enter the MENUS.
2. Press to highlight Configure Device.
3. Press to select Configure Device.
4. Press to highlight SYSTEM SETUP.
44 Chapter 2 Control panel ENWW