HP 17 - Manual (Page 57)

Remove the WLAN module:
1. Disconnect the WLAN antenna cables from the terminals on the WLAN module.
NOTE: The 1/black WLAN antenna cable is connected to the WLAN module 1/Main terminal.
The 2/gray WLAN antenna cable is connected to the WLAN module 2/Aux terminal. If a third
antenna cable is present, it is connected to the WLAN module middle terminal.
2. Remove the Phillips PM2.0×2.8 screw that secures the WLAN module to the system board. (The
WLAN module tilts up.)
ENWW Component replacement procedures 49