Honeywell HRSD4 User Manual
Page 90
Configuration
90
Figure 3-56
DVRNS Setup Screen
1.
Highlight the box beside Use DVR Name Service and press
to toggle
between On and Off. When On, the entire setup screen becomes active.
2.
Highlight the field beside DVRNS Server and use the virtual keyboard to enter the
IP address or domain name of the DVRNS server.
Note
You need to get the IP Address or domain name of the DVRNS
Server from your network administrator.
Note
You can use the domain name instead of the IP address if you
already set up the DNS Server during the LAN Setup.
3.
Highlight the field beside Port and enter the port number of the DVRNS server.
The port number can be set from 10000 to 12000.
Note
The DVRNS server settings on your DVR should match the
settings on the registered DVRNS server. Any changes on the
DVRNS server might cause improper operation.
4.
Highlight the Use NAT field and press
to toggle On and Off.
Note
When using the NAT (Network Address Translation) device, refer
to the NAT manufacturer's instructions for the proper network
settings.