Honeywell HRSD4 - Manual (Page 93)

Configuration
Document 800-00919 Rev F 93
02/08
Note Authentication should be turned On and the ID and Password
should be entered when using an SMTP server requiring user
authentication.
Setting Up the Callback Center to Contact a Pager
You can set the DVR to dial a pager and leave a four- or five-digit message when an
event occurs. This message is a code, as shown in
Table 3-10 . The first three digits of
the message are the site ID number. The last digits are the type of event.
For example, 0754 means that Site 75 has lost video.
From the Main menu, select Network, then Callback Center, and then press . The
Callback Center (Modem) setup screen appears because you selected Modem as the
network connection type in the Network Setup screen (see
Setting the Connection Type
on page 83 ).
Table 3-10 Callback Center Pager Codes
Code Translation
1 Alarm In
2 Text-In
3 Motion Detection
4 Video Loss
10 Check Recording
11 Storage
13 S.M.A.R.T.
18 System