Hand Held Products 5700 - Manual (Page 34)

2–10 SCANTEAM 5700 User’s Guide
Enable ✱
Disable
Code I.D. Transmit Selection
Enable ✱
Disable
AIM I.D. Transmit Selection
✱
Enable Disable
Function Code Transmit Selection
✱
Enable Disable
Buffered Scans Selection
This allows you to enable or disable transmission of a Code I.D. before the
decoded bar code symbology. (See the Symbology Chart on page 2–7 for the
single character code that identifies each symbology.)
When this selection is enabled, and function codes are contained within the
scanned data, the scanner transmits the key code (which corresponds to the
decoded ASCII function code) to the terminal. ASCII function codes are
represented by the HEX values 00–1F. (Charts of these function codes are
shown in Section 6, Supported Interface Keys.)
This selection allows you to enable or disable transmission of an AIM I.D. before
the decoded bar code symbology. (See AIM Guidelines on Symbology
Identifiers for more information on the AIM symbology ID characters.) Default
= Disable.
When enabled, this selection allows the scanner to accept a second scan while
the current scan is transmitted to the host terminal (buffering of scanned data).
When disabled, the scanner cannot accept additional scans until the current
scan is transmitted to the host. Default = Enable.