Hand Held Products 5700 - Manual (Page 37)

2–13 SCANTEAM 5700 User’s Guide
✱
Record
Protocol Selection
Xon / Xoff Ack / Nak
To P2 To P1 and P2
Serial Wedge Output Selection
✱
To P1
This selection allows you to program the scanner for the protocol required by
your application. The protocol is a set of rules concerning the exchange of data
between serially communicating devices. The scanner supports Record,
Xon / Xoff, and Ack / Nak protocols when receiving data from an RS-232 device.
This selection allows you to select the serial output direction required by your
application. P1 and P2 are serial wedge designations printed on the serial wedge
cable. Usually, one goes to the host and one goes to the terminal, depending on
your specific application and the serial wedge cable.
Note: Serial Wedge programming is for scanner model –X3 only! The scanner
must also be in Serial Wedge mode (Terminal I.D. 50).