Hand Held Products 5700 - Manual (Page 35)

2–11 SCANTEAM 5700 User’s Guide
✱ Default All Serial Communication Settings ✱
Enable ✱
Disable
CTS Check Selection
300 600
Baud Rate Selection
1200 2400
4800 ✱
9600
19200 38400
This selection allows you to select the software programming feature that checks
for a CTS signal, if your application does not have a CTS I/O line. Default =
Disable.
This selection sets the baud rate from 300 bits per second to 38,400 bits per
second. Programming baud rate causes the data to be sent at the specified rate.
The host terminal must be set up for the same baud rate as the scanner, to ensure
reliable communication. Default = 9600 bps.