Ncr 7052 keypad selection, At direct connect selection – Hand Held Products 5700 User Manual
Page 47
3–5
SCANTEAM 5700 User’s Guide
Note: The following Enable and Disable programming bar codes apply to
SCANTEAM 5700 software prior to software revision level 2.0.
NCR 7052 Keypad Selection
[
Layout 2 (Calculator)
Layout 3 (PC AT)
✱
Layout 1 (Telephone)
AT Direct Connect Selection
[ NCR 7052 applies to –X1 units only.
This selection allows you to connect the scanner directly to your terminal. No
keyboard is necessary when this selection is enabled.
Default = Disable.
This selection allows you to program the scanner to transmit the proper
keycodes when interfacing with a telephone, calculator, or PC AT type numeric
keypad layout. Choose the keypad layout that defines your keypad layout.
Default = Layout 1 (Telephone).
Note: A direct connect cable is optional (versus “Y” cable) and may be ordered
from your distributor.
Note: NCR 7052 Keypad applies to the 5700–X1 models only.
Enable
✱
Disable