Hand Held Products 5700 - Manual (Page 54)

4–4 SCANTEAM 5700 User’s Guide
✱ Default All Code 39 Settings ✱
Code 39
✱
On Off
Transmit ✱
Don’t Transmit
Start / Stop
Characters
Full ASCII
✱
Enable Disable
Append
Enable ✱
Disable
] A two-digit number is required after scanning this programming bar code.
Scan your selection on the Programming Chart (inside back cover).
Code 39 Selection
Refer to the Full ASCII
Chart on page 4–6.
Programming Tip: If a symbology will not be used, we recommend turning it
off to minimize the chance of a misread.