HP ISCSI SR2122 - Manual (Page 51)

Serving Storage to the iSCSI Initiators from the SR2122 over IP
51 iSCSI SR2122 Storage Router: Getting Started Guide
Follow the prompts on the screen and accept the license agreement and at the iSCSI
Configuration screen, you may enter the SCSI Router Instance IP addresses that the iSCSI
Initiator is to use for storage. An iSCSI Initiator may communicate with up to eight SCSI
Router Instances.
A system reboot is necessary after the driver installation.
When HP's Windows iSCSI driver is loaded on the iSCSI initiator, it also creates a hp iSCSI
Config icon that is accessed through the Control Panel.
Open the hp iSCSI Config configuration screen and add the IP addresses of the newly created
SCSI Router Instances from each SR2122 Node A and Node B, 33.33.33.103 and
33.33.33.104 respectively
Figure 32: Iscsi03 HP Config Screen Example
Click SAVE and reboot the iSCSI Initiator to apply.
After the server reboots enter hp iSCSI Config again and check the Status of the driver to verify
both the SR2122 targets are active.