Chapter 2 installation instructions – Foxconn N570SM2AA User Manual
Page 23
Chapter 2 Installation Instructions
16
Serial ATA II Connectors: SATA_1, SATA_2,
SATA_3, SATA_4, SATA_5, SATA_6, E_SATA2
The Serial ATA II connectors are used to connect
the Serial ATA II devices to the motherboard.
These connectors support the thin Serial ATA II
cables for primary storage devices. The current
Serial ATA II interface allows up to 300MB/s data
transfer rate.
E_SATA2 Connector Supports RAID 0, RAID 1,
RAID 0+1, JBOD Function. The other serial ATA
II connectors support RAID 0, RAID 1, RAID 0+1,
RAID 5 Function.
The fan speed can be detected and viewed in
“PC Health Status” section of the CMOS Setup.
These fans will be automatically turned off after
the system enters S3, S4 and S5 mode.
Fan Connectors: CPU_FAN, SYS_FAN,FAN
USB Headers: F_USB1, F_USB2,F_USB3
Besides four USB ports on the rear panel, the
series of motherboards also have three 10-pin
headers on board which may connect to front
panel USB cable to provide additional six USB
ports.
F_USB 1/2/3
1
5V_DUAL
D-
D+
D-
GND
GND
D+
NC
Empty
5V_DUAL
Additional COM Connector: COM1
This motherboard provides an additional serial
COM header for your machine.
Connect one side of a switching cable to the
header, then attach the serial COM device to the
other side of the cable.
COM1
SOUT
GND
RLSD
RI#
DTR#
DSR#
SIN
9
10
1
2
CTS#
RTS#
Empty
SATA II Connector
1
GND GND
GND
RX+
RX-
TX -
TX +
SYS-FAN
FAN
CPU_FAN
SENSE
GND
1
POWER CONTROL
+12V
GND
SENSE
1
PDF 文件使用 "pdfFactory" 试用版本创建