Foxconn N570SM2AA User Manual
Page 45
Chapter 3 BIOS Description
38
v
HDD Power Down
This option is used to turn off hard disk power if the hard disk is idle for a given
period of time. The setting values are Disabled and 1Min-15Min.
v
HDD Down In Suspend
This option is used to define the continuous HDD idle time before the HDD
enters power saving mode. The setting values are Disabled and Enabled.
v
Soft-Off by PBTN
This option is used to set the power down method. This function is only valid
for systems using an ATX power supply. When “Instant-Off” is selected, press
the power switch to immediately turn off power. When “Delay 4 Sec.” is selecte-
d, press and hold the power button for four seconds to turn off power.
v
WOL(PME#) From Soft-Off
When set to Enable, the feature allows your system to be awakened from the
power saving modes through any event on PME (Power Management Event)
v
WOR(RI#) From Soft-Off
If this item is enabled, it allows the system to resume from a software power
down or power saving mode whenever there is an incoming call to an install-
ed fax/modem. This function needs to be supported by the relevant hardware
and software.
v
USB Resume From S3
This item is used to set the system to wake up by USB equipment when it is
in S3 (Suspend to RAM) mode.
v
Video Off Method
This option is used to define the video off method. “Blank Screen” mode
means that after the computer enters power saving mode, only the monitor
will close, however, the vertical and horizontal scanning movement of the screen
continues. When you select the “V/H SYNC + Blank” mode the vertical and horizontal
scanning movement of screen stops when the computer enters power saving
mode. “DPMS Supported” mode is a new screen power management system,
and it needs to be supported by the monitor you’re using.
PDF 文件使用 "pdfFactory" 试用版本创建