Fortinet MR1 - Manual (Page 366)

366
Default Setting
Both
Command Mode
Interface Config
6.6.2.13 ip rip send version
This command configures the interface to allow RIP control packets of the specified version
to be sent.
The value for <mode> is one of: rip1 to broadcast RIP version 1 formatted packets, rip1c
(RIP version 1 compatibility mode) which sends RIP version 2 formatted packets via
broadcast, rip2 for sending RIP version 2 using multicast, or none to not allow any RIP
control packets to be sent.
Syntax
ip rip send version {rip1 | rip1c | rip2 | none}
no ip rip send version
no - This command configures the interface to allow RIP control packets of the default version to be sent.
Default Setting
Rip2
Command Mode
Interface Config
6.7 Router Discovery Protocol Commands
6.7.1 show ip irdp
This commands displays the router discovery information for all interfaces, or a specified
interface.
Syntax