Fortinet MR1 - Manual (Page 627)

627
Configurable Data
Source IP - Enter the IP Address that identifies the multicast packet source for the entry you are
creating.
Source Mask - Enter the subnet mask to be applied to the Source IP address.
RPF Neighbor - Enter the IP address of the neighbor router on the path to the source.
Metric - Enter the link state cost of the path to the multicast source. The range is 0 - 255 and the default
is one. You can change the metric for a configured route by selecting the static route and editing this
field.
Slot/Port - Select the interface number from the dropdown menu. This is the interface that connects to
the neighbor router for the given source IP address.
Command Buttons
Submit - Send the updated configuration to the router. Configuration changes take effect immediately.
These changes will not be retained across a power cycle unless a save is performed.
Delete - Delete the static entry with the selected Source IP address from the MRoute table.
Viewing Multicast Static Routes Configuration Page
Non-Configurable Data
Source IP - The IP Address that identifies the multicast packet source for this route.
Source Mask - The subnet mask applied to the Source IP address.
RPF Address - The IP address of the RPF neighbor.
Metric - The link state cost of the path to the multicast source. The range is 0 - 255.
Slot/Port - The number of the incoming interface whose IP address is used as RPF for the given source
IP address.
Command Buttons
Refresh - Refresh the data on the screen with the present state of the data in the router.