Fortinet MR1 User Manual
Page 498
498
Selection Criteria
Static - Displays static unit for L2Mcast Groups.
Dynamic - Displays dynamic unit for L2Mcast Groups.
All - Displays all of L2Mcast Groups.
Configurable Data
Filter - Specify the entries you want displayed.
Static: If you choose "Static" only L2Mcast addresses that have been configured will be displayed.
Dynamic: If you choose "Dynamic" only L2Mcast addresses that have been learned will be
displayed.
All: If you choose "all" the whole table will be displayed.
MAC Address Search - You may also search for an individual L2Mcast address. Enter the six byte
hexadecimal MAC address, for example 01:00:5E:00:11:11.
VLAN - You also have to give a VLAN ID you want with L2Mcast address.
Then click on the search button. If the address exists, that entry will be displayed as the first
entry followed by the remaining (greater) MAC addresses. An exact match is required.
Non-Configurable Data
VLAN - L2Mcast Group's VLAN ID value.
MAC Address - A multicast MAC address for which the switch has forwarding information. The format is
a six-byte MAC address. For example: 01:00:5E:00:11:11.
Slot/Ports - the interface number belongs to this Multicast Group.
Type - The status of this entry. The possible values are:
Static: the entry was configured by setting a static L2Mcast.
Dynamic: the entry was configured by setting a dynamic L2Mcast.
All: the entry was configured by setting the whole L2Mcast table.
Command Buttons
Search - Search for the specified L2Mcast address.
Refresh - Refresh the database and display it again starting with the first entry in the table.