Furuno 1834C-BB - Manual (Page 57)

2. RADAR OPERATION
2-30
2.26.5 Setting vector attributes (ARP)
What is a vector?
A vector is a line extending from a tracked target which shows estimated speed and course
of the target. The vector tip shows an estimated position of the target after the selected
vector time elapses. It can be useful to extend the vector length (time) in order to evaluate
the risk of collision with any target.
Vector
Vector
Vector reference, vector time
You may reference the vectors to North (True, requires heading and speed data) or ship’s
heading (relative) as desired. Vector time can be set to 30 seconds, 1, 3, 6, 15 or 30
minutes.
1. Press the MENU key followed by the C: ARP SETUP soft key to show the ARP SETUP
menu.
2. Operate the Trackball to select ARP VECTOR MODE.
3. Press the A: EDIT soft key to show the ARP vector mode window.
ARP VECTOR MODE
RELATIVE
TRUE
ARP vector mode window
4. Select TRUE or RELATIVE as appropriate.
5. Press the C: ENTER soft key.
6. Select ARP VECTOR TIME, then press the A: EDIT soft key to show the ARP vector
time window.
ARP VECTOR TIME
▲
▼
30 seconds
1 minute
3 minutes
6 minutes
15 minutes
30 minutes
ARP vector time window
7. Operate the Trackball to select vector time among 30 sec, 1 min, 3 min, 6 min, 15 min
and 30 min.
8. Press the C: ENTER soft key.
9. Press the MENU key to close the menu.