Furuno 1834C-BB - Manual (Page 9)

viii
SYSTEM CONFIGURATIONS
All NavNet products incorporate a “network circuit board” to integrate each NavNet product
on board through an optional LAN cable (Ethernet 10BASE-T). Each NavNet product is
assigned an IP address to enable transfer of images between other NavNet products. For
example, video plotter pictures can be transferred to a radar and vice versa. Pictures
received via the NavNet may be adjusted at the receiving end.
The number of processor units which may be installed depends on the number of network
sounder connected. For a system incorporating three or more products, a “hub” is required
to process data.
For one network sounder: one radar and three plotters, or four plotters
For two network sounder: one radar and two plotters, or four plotters
Note:
NavNet2 equipment cannot be connected to initial version NavNet equipment.
NavNet system (Model 1824C-BB/1834C-BB/1934C-BB/1944C-BB/1954C-BB/
1964C-BB)
Heading sensor
Navigator
Echo sounder
Rectifier
RU-3423
GPS receiver
GP-310B/320B
12 - 24 VDC*
Network
Sounder
ETR-6/10N
ETR-30N
Other NavNet
system
(GD-1920C-BB, etc.)
Antenna Unit
MODEL
1834C-BB
MODEL
1934C-BB
MODEL
1944C-BB
Processor unit
RPU-015
100/110/115/220/230 VAC
1
φ , 50/60 Hz*
Monitor
(Local supply)
MODEL
1954C-BB
Control unit
RCU-017
*: The power for the power supply unit
and display unit must be drawn from
the same power source.
Facsimile
Receiver
FAX-30
MODEL1824C-BB
PUSH TO ENTER PUSH TO ENTER
DEF DEF
MNO MNO
VWX VWX
_'# _'# POWER POWER
RANGE RANGE
TX TX 0 0
JKL JKL 4 4
7 7 STU STU
5 5
8 8
ABC ABC 2 2 1 1 B B
GAIN GAIN
ALARM ALARM
EBL EBL VRM VRM
PQR PQR
YZ& YZ&
6 6
9 9
DISP DISP
E E
MENU MENU C C
D D
CLEAR CLEAR GHI GHI 3 3 SAVE SAVE MOB MOB HIDE HIDE SHOW SHOW A A
POWER
DATA 3 NETWORK CONT DATA 1 DATA 2
DJ-1
SLAVE DISPLAY
RGB OUT
NTSC/PAL
2
GND 3 INPUT 12-24 VDC 1
CARD SLOT
3 2 1
GND
F.G.
12 VDC OUTPUT
OPTION
: Standard
: Option
: Local supply
MODEL
1964C-BB
Power Supply Unit
PSU-005
(MODEL 1954C-BB)
Power Supply Unit
PSU-008
(MODEL 1964C-BB)
ARPA ARP-11 (Built-in)
AIS transponder
AIS Interface
IF-1500AIS*
* Not required for AIS
Transponder FA-150
NavNet system (Model 1824C-BB/1834C-BB/1934C-BB/1944C-BB/1954C-BB/1964C-BB)