Furuno DD-80 - Manual (Page 53)

7 – 3
7.5 Trip Alarm
The trip alarm sounds when the distance run
is greater than the trip alarm setting.
1) Press [MENU ESC] and [4].
2) Press ▲ or ▼ to select Next Page. The
menu shown in Figure 7-6 appears.
To Previous Page
On
Off
Trip Range 0123.00nm
Water Temp. In Over Off
Temp. Range +12.0 ~ +15.0
° C
Depth In Over Off
Depth Range 0003.0 ~ 0200.0ft
ALARM SETTINGS 2/2
MENU : Escape
: Select ENT : Enter
: +/-
Trip (CLR:Reset) Off
DGPS Alarm On Off Off
Figure 7-6 Alarm settings menu, page 2/2
3) Press ▲ or ▼ to select Trip.
4) If necessary, press [CLEAR] to reset the
trip distance and trip elapsed time.
5) Press t or s to select On.
6) Press ▼ to select Trip Range.
7) Key in trip range.
8) Press the [NU/CU ENT] key.
9) Press the [MENU ESC] key.
When the ship's distance run is higher than
the trip range set here, the buzzer sounds and
the message "Trip alarm" appears.
7.4 Speed Alarm
The speed alarm sounds when ship's speed is
lower or higher (or within) the alarm range
set.
1) Press [MENU ESC] and [4].
2) Press ▲ or ▼ to select Ship Speed.
3) Press t or s to select In or Over.
In: Alarm sounds when speed is within
range set.
Over: Alarm sounds when speed is higher
or lower than range set.
4) Press ▼ to select Speed Range.
5) Key in low speed.
6) Key in high speed.
7) Press the [NU/CU ENT] key.
8) Press the [MENU ESC] key.
When speed is higher or lower (or within) than
the speed set here, the buzzer sounds and the
message "Speed alarm" appears.