Furuno DD-80 - Manual (Page 63)

8-9
8) Press the [MENU ESC] key twice.
Saving data to personal computer
Waypoint and route data can be saved to a
personal computer.
1) Press [MENU ESC] [9] and [5].
2) Press ▲ or ▼ to select Level.
3) Press t or s to select level; RS232C or
RS422.
4) Press the [NU/CU ENT] key. "Data" ap-
pears in reverse video.
5) Press s to select Com.
6) Press ▼ to select Next Page.
7) Press ▲ or ▼ to select Baud Rate.
8) Press t or s to select baud rate; 400bps,
9600bps, or 19200bps.
9) Press ▼ to select Command (under the
Save Data line). Stop, on the same line as
Command, appears in reverse video.
10) Press s to select Start. The message
shown in Figure 8-21 appears.
Are you sure to save ?
ENT: Yes MENU:No
Figure 8-21
11) Press the [NU/CU ENT] key. The mes-
sage shown in Figure 8-22 appears while
data is being saved.
Now saving
Waypoint/Route data !
MENU:Stop
Figure 8-22
12) Save data at the computer.
13) Press the [MENU ESC] key. When data
is saved, the cursor shifts to Stop.
14) Press the [MENU ESC] key.
8.6 DGPS Settings
A DGPS beacon receiver may be connected
to the DD-80 to further refine position accu-
racy. Set up to receive the DGPS beacon sig-
nal as follows.
Selecting DGPS station
The default setting is "manual".
Automatic
The DGPS beacon receiver can automatically
select optimum reference station by feeding
it position data. If it takes more than 5 min-
utes to fix DGPS position at the automatic
mode, switch to manual mode. Use at manual
mode when a external beacon receiver has no
automatic function of station selection.
1) Press [MENU ESC] [9] and [7] to dis-
play the DGPS SETUP menu.
Ref. Station Auto Man (ID= )
Freq. 288.0kHz
Baud Rate 200 bps
DGPS SETUP
MENU : Escape ENT : Enter
: Select
Ref. Station Auto
Frequency appears when
"MAN" is selected.
DGPS MODE On Off
Figure 8-23 DGPS SETUP menu
2) Set DGPS MODE On.
3) Press ▲ or ▼ to select Ref. Station.
4) Press t or s to select Auto.
5) Press the [NU/CU ENT] key.
6) Press the [MENU ESC] key.