FARGO electronic Pro-LX Laminating Card Printer/Encoder - Manual (Page 182)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0) 182
Selecting the Pause for Low Ribbon checkbox
Use this option to generate a definitive warning when the Print Ribbon is running low. (Note:
When this option is selected, the Printer will "beep", pause and the Ready LED will flash
when approximately 10 to 20 prints remain on the Print Ribbon.)
Step Procedure
1 Replace the ribbon and press the Pause/Resume button to continue printing
with a new ribbon.\
OR
Leave the existing ribbon in the Printer and press the Pause/Resume button.

Once the Pause/Resume button is pressed, the Printer will continue
printing until the end of the ribbon, but will beep once before each print job.

It will not be necessary to press the Pause/Resume button again to
continue printing once it has been pressed initially during a batch print.)

The Printer will still beep once before each print job when approximately 10
to 20 prints remain on the Print Ribbon; however, the Printer will not pause.
Instead, it will continue printing until the end of the ribbon, without User
intervention.