Furuno CI-35H - Manual (Page 48)

4-6
* MENU 3 * KNOB ITEM
Jan/15/1997
KNOB SETUP
END : MENU KEY
MENU MODE : MENU1 MENU2 MENU3 MENU4
SHIP SPD AVR : 15sec
DRAFT : 0.0 m
WT SPD DEPTH : 2.0 m
HEEL ANGLE : 0.0 °
TRIM ANGLE
GT SPD CALIB
: 0.0 °
: 0.0 %
WT SPD CALIB : 0.0 %
BEARNG CALIB : 0.0 °
COURSE CALIB : 0.0 ° (GT 0. 0 ° ) (NAV 0. 0 ° )
EXT KP1 DIST : 0.0 m
EXT KP2 DIST
BTM TIDE TRK
: 0.0 m
: OFF ON
Knob
Knob
!0 Offset angle to align course by CI-35/35H and course by external naviator [GPS] (-12.8 to
+12.7°)
(GTx.x and NAVx.x are offset angles calculated by “CRS CALIB EXEC” operation in MENU 4.)
9 Bearing offset angle of transducer (-12.8 to +12.7°)
“-”: transducer’s fore-aft axis deviated to port
“+”: transducer’s fore-aft axis deviated to starboard
8 Ship speed offset in water tracking mode
7 Ship speed offset in ground tracking mode
6 Fore-aft inclination angle (-12.8 to +12.7°)
“-”: aft-high “+”: fore-high
5 Lateral (port-starboard) inclination angle (-12.8 to +12.7°)
“-”: starboard-high “+”: port-high
4 Reference depth to measure ship’s speed in water tracking mode......(2.0 to 25.6 m)
3 Draft level; i.e., depth of transducer from sea surface......(0.0 to 25.6m)
2 Averaging time for ship speed/course display......(15/30/60/90 sec)
1 Press key to store (validate) the settings and to close the menu window.
MENU 3
(NOTE 1)
(Note 2)
(Note 4)
(Note 6)
1
2
3
4
5
8
9
!0
!3
(Note 3)
(Note 5)
6
7
!1
!2
!1 Distance between transducers of CI-35/35H and other sounding device which is connected to
the CI-35/35H as interfering source 1. (KP1)
!2 Distance between transducers of CI-35/35H and other sounding device which is connected as
interfering source 2. (KP2)
!3 Used to select depth setting of layer 3.
“OFF”: Manual setting
“ON”: Automatic tracking on near-bottom tide
MENU