Furuno CI-35H - Manual (Page 57)

4-15
Turn knob to set a distance-run, and then hit the EVENT key.
A filled star mark “ ” appears aside “DIST” to show the distance alarm setting valid.
To start counting distance, press the TRIP key. Note that the alarm distance counting is
perfomed internally but not shown on the display. When the preset alarm distance is reached,
time-elapsed display becomes red and the counting is stopped. If the audible alarm is en-
abled (“
”), it is released.
B. To set a trip alarm, turn knob for “TIME ” options and hit the EVENT key. The
following sub-window appears.
DISTANCE RUN ALARM KNOB ITEM KNOB SETUP
EXEC : EVENT
TRIP TIME : 0 HOUR
: 15 MINUTE
: 0 SECOND
After selecting hour, minute and second by the knob, set your desired trip time (alarm limit) by
the knob. Then, press the EVENT key to store the setting. A filled star “ ” appears aside
“TIME” to show the trip time alarm setting is valid.
To start counting trip time, press the TRIP key. Note that the trip time counting is preformed
internally, but not shown on the display. Instead, distance-run in the TRIP display frame counts up.
When the preset trip time is reached, the distance-run display becomes red and the counting is
shopped. If the audible alarm is enabled (“
”), it is released.