Furuno CI-35H - Manual (Page 50)

4-8
* MENU 4 * KNOB ITEM
Jan/15/1997
KNOB SETUP
END : MENU KEY
MENU MODE : MENU1 MENU2 MENU3 MENU4
TIME DATA : INT EXT
WT SPEED : T/D
NAV FORMAT : CIF
NAV AID : GPS
NAV DATA
: LORAN-A
: L/L
TIME INT : 1min
CRS CAL MODE : GT
CRS CAL EXEC : START
TIDE OUT INT : 15sec
Knob Knob
NAV-TIDE
NMEA
LORAN-C
ALL
SPD
NAV
DECCA
MAN
DR
!0 Selection of data output interval (15sec, 30sec,1min, 2min, 5min or 10min)
9 Used to calculate course calibration angle if “or” is selected in CRS CAL MODE adove.
(Press EVENT key to start.)
8 Selection of method for automatic cource calibration calculation and calibration mode to use
“GT”: Calculates course calibration angle to equalize ground tracking course to that of
external navigator after 2 mile run.
“NAV”: Calculates course calibration angle to equalize tides before and after 10 minute
period.
“MAN”: Calculates course by using value entered manually in MENU 3-COURSE CALIB.
7 Averaging time for converting position change into speed/data(1 to 10 min in 1 min steps,
effective only when selected “L/L” as NAV DATA above)
6 Selection of source data for ship’s speed/direction display in nav-aided mode
5 Selection of source navigator to receive spd/pos data
4 Selection of communication data format with external navigator (Furuno CIF or NMEA0183)
3 Selection of tracking mode when ground tracking unattainable (water tracking or nav-aided)
2 Selection of date/time display by internal clock (CI-35/35H) or external navigator’s clock
(GPS)
1 Press key to store (validate) the settings and to close the menu window.
MENU 4
(Note 1)
(Note 2)
(Note 3)
(Note 4)
1
2
3
4
5
7
8
9
!0
(Note 5)
(Note 6)
(Note 7)
(Note 8)
6
MENU