Grizzly G0588/G0591 - Manual (Page 23)

G0588/G0591 12" Sliding Table Saws
-15-
3. Remove the control panel surrounding plate
and the cover.
4. Replace the 220V magnetic switch (Figure
7) with the 440V magnetic switch. Set the
dial on the new overload relay to 11A.
Note: The magnetic switch consists of the
magnetic contactor and the overload relay.
7. Rewire the motor per the diagram on the
inside of the motor wiring cover.
Overload
Relay Dial Overload
Relay
Figure 7. Magnetic switch.
6. Open the motor cabinet door and remove the
motor wiring cover (see Figure 8).
Figure 8. Motor location.
Magnetic
Contactor
5. Replace the control panel cover, surrounding
plate, and the cover plate.
Motor Wiring
Cover