Grizzly G0588/G0591 - Manual (Page 31)

G0588/G0591 12" Sliding Table Saws
-23-
Rip Fence and Scale
Components and Hardware Needed: Qty
Aluminium Rip Fence .........................................1
Rip Fence Round Rail ........................................1
Rip Fence Body ..................................................1
Rip Fence Lock Handle ......................................1
Square Tube w/Scale .........................................1
Flat Washers 6mm .............................................3
Hex Nuts M6-1 ...................................................3
Cap Screws M6-1 x 20 .......................................5
To install the rip fence:
1. Remove a hex nut and a flat washer from
each of the studs in the round rail.
2. Insert the studs into the table as shown in
Figure 22, and loosely secure with the hex
nuts and a flat washers removed in
Step 1.
Figure 22. Installing the round rail.
3. Align the square tube w/scale parallel with
the top of the table and secure with the cap
screws (see
Figure 23). Secure the cap
screws in the extension table with M6-1 hex
nuts and flat washers.
Figure 23. Attaching the scale.
4. Thread the rip fence lock handle into the rip
fence body.
5. Remove the stop screw from the left end of
the rip fence round rail, slide the rip fence
body onto the rail and move it all the way to
the left.
6. Adjust the nut shown in Figure 24 until the
teeth of the pinion gear on the underside
of the rip fence mesh with the teeth on the
square tube. Tighten the hex nut inside the
lip of the table to secure the stud.
Figure 24. Aligning the round rail.
Adjusting Nut
Stop
Screw