Grizzly G0588/G0591 - Manual (Page 53)

G0588/G0591 12" Sliding Table Saws
-45-
SECTION 7: SERVICE
Always disconnect
power to the machine
before performing ser-
vice adjustments. Failure
to do this may result in
serious personal injury.
This section is designed to help the operator with
adjustments that were made at the factory and
that might also need to be made during the life of
the machine.
This section is provided for your convenience—
it is not a substitute for the Grizzly Service
Department. If any adjustments arise that are not
described in this manual, then feel free to call the
Grizzly Service Department at (570) 546-9663.
Similarly, if you are unsure of how to perform
any procedure in this section, the Grizzly Service
Department will be happy to guide you through
the procedures or help in any other way.
About Service
To ensure optimum power transmission from the
motor to the blades, the belts must be in good
condition (free from cracks, fraying and wear) and
operate under proper tension.
To change the main blade arbor V-belt:
1. Disconnect the saw from the power
source!
2. Move the blade tilt to 45˚, lower the main
blade all the way down, and open the motor
cabinet door.
3. Loosen the belt tension bolt (Figure 80) and
pivot the motor up.
Replacing Belts
Figure 80. V-belt tension bolt.