Grizzly G0588/G0591 - Manual (Page 26)

-18-
G0588/G0591 12" Sliding Table Saws
Figure 11. Extension table components.
B C
D
Inventory
After all the parts have been removed from the
two boxes, you should have the following items:
Crate 1 .......................................................... Qty
A. Saw Base Unit (Not Shown) ...................... 1
B. Large Extension Wing ................................ 1
C. Small Extension Wing ................................ 1
D. Support Leg ................................................ 1
E. Rip Fence Round Rail w/M12 Studs,
Washers, and Nuts ..................................... 1
F. Square Tube w/Scale ................................. 1
G. Rip Fence Body .......................................... 1
H. Rip Fence Lock Handle .............................. 1
I. Aluminium Rip Fence ................................. 1
Figure 12. Rip fence components.
E
F
G
H
The unpainted surfaces are coated with a waxy
oil to protect them from corrosion during ship-
ment. Remove this protective coating with a sol-
vent cleaner or citrus-based degreaser such as
Grizzly’s G7895 Degreaser. To clean thoroughly,
some parts may need to be removed.
For opti-
mum performance from your machine, make
sure you clean all moving parts or sliding
contact surfaces that are coated. Avoid chlo-
rine-based solvents, such as acetone or brake
parts cleaner, as they may damage painted sur-
faces should they come in contact. Always follow
the manufacturer’s instructions when using any
type of cleaning product.
Clean Up
Gasoline and petroleum
products have low flash
points and could cause
an explosion or fire if
used to clean machinery.
DO NOT use gasoline or
petroleum products to
clean the machinery.
Many of the solvents
commonly used to clean
machinery can be toxic
when inhaled or ingest-
ed. Lack of ventilation
while using these sol-
vents could cause seri-
ous personal health risks
or fire. Take precautions
from this hazard by only
using cleaning solvents
in a well ventilated area. I