Grizzly G0588/G0591 - Manual (Page 38)

-30-
G0588/G0591 12" Sliding Table Saws
Crosscut Fence
Components and Hardware Needed: Qty
Crosscut Aluminium Fence ................................1
Lock Knobs M10-1.5 ...........................................2
Flip Stops ...........................................................2
To install the crosscut fence:
1. Insert the T-bolts in the places indicated in
Figure 43.
Crosscut Table
Figure 42. Installing the crosscut table.
Components and Hardware Needed: Qty
Crosscut Table ...................................................1
Crosscut Table Lock Plate ..................................1
Adjustable Handles M10-1.5 ...............................1
Flat Washers 10mm ...........................................2
To install the crosscut table:
1. Thread the adjustable handles, with 10mm
flat washers, two or three turns onto the studs
in the lock plate.
2. Slide the lock plate into the T-slot in the side
of the sliding table.
3. With the help of an assistant, place the
crosscut table on the pivot pin of the swing
arm and over the studs of the lock plate (see
Figure 42).
4. Insert the indexing blocks into the T-slot and
lock the crosscut table in place with the adjust
levers.
Figure 43. Crosscut fence placement.
2. Place a framing square along the edge of
the sliding table and use the crosscut fence
adjustment screw (
Figure 44) to align the
fence perpendicular to the sliding table.
Note: Follow the instructions on Page 48 to
make the fence perfectly perpendicular.
Figure 44. Crosscut fence adjustment screw.
T-Bolt
Placement