Grizzly G0700 - Manual (Page 27)

Model g0700 (Mfg. since 8/09)
-25-
26. Move the fence out of the way, and install the
blade guard ( figure 25) per the instructions
on page 31. (this step is mandatory.)
28. install the hose support as shown in figure
27.
figure 27. hose support installed.
hose
support
Hose
Support
Lock Washer
10mm
Flat Washer
10mm
Large
Extension
Table
Cap Screw
M10-1.5 x 25
Hex Nut
M10-1.5
figure 26. Miter gauge installed.
Miter gauge
27. install the miter gauge as shown in figure
26.
figure 25. Blade guard installed.
Blade guard
do not operate this saw without an ade-
quate dust collection system. this saw cre-
ates substantial amounts of wood dust while
operating. failure to use a dust collection
system can result in short and long-term
respiratory illness.
25. Make sure the fence is just touching the edge
of the blade teeth, then adjust the position of
the rip fence scale until the edge of the fence
is aligned with the 0" mark on the scale. once
it is aligned, carefully tighten the rip fence
scale fasteners.