Grizzly G0700 - Manual (Page 29)

Model g0700 (Mfg. since 8/09)
-27-
power connection
Before connecting the saw to power, read through
section 2: poWer supply, beginning on
page 12, to check that your setup follows the
safety and circuit requirements for your model.
When installing the power cord, it is Mandatory
to make sure the cord is adequately secured to
the junction box with a strain relief, so it will not be
pulled loose if tripped over or caught on a moving
object. the strain relief firmly attaches to the junc-
tion box and clamps against the cord when tight-
ened. also, it is important to firmly tighten terminal
screws, so wires cannot come loose from any
operational vibrations that may occur over time.
if the cord or wires are pulled loose, the wires can
cause a short, which may lead to fire, shock, or
machine damage.
4. Make sure the wires have adequate slack
between the strain relief and the terminals,
then tighten the strain relief against the power
cord jacket—not the wires.
5. test the strain relief by pulling on the cord
from outside the box, using moderate force.
When properly secured, the cord will remain
in place and not slide in the strain relief.
6. replace the power box cover.
7. Connect the required plug to the other end of
the power cord, using the wiring instructions
provided by the plug manufacturer.
if the wiring instructions are not provided
with the plug, refer to the wiring diagram in
this manual. the plug wiring shown in the
diagram is drawn from neMa standards for
the plug type shown. if your plug does not
match the one shown in the wiring diagram in
this manual, please contact technical support
before proceeding any further.
8. Clear away any tools used during the assem-
bly process, and press the stop button on
the magnetic switch to ensure that the on
button is not engaged.
9. plug the machine into the power source and
proceed to the following test run section to
verify that the saw operates correctly and is
ready for cutting operations.
figure 31. Location of junction box and strain
relief.
Junction Box
strain
relief
2. Loosen the strain relief and slide the power
cord through it and into the junction box.
to connect the saw to the power supply:
1. open the junction box shown in figure 31.
make sure power cord is
not connected to power
when wiring it to the
junction box. connect
machine first, then con-
nect wires to the plug!
figure 32. Location to connect incoming power
supply wires inside junction box.
r (Black)
s (White/red)
ground (green)
3. attach the hot wires to the terminals across
from the wires marked "s" and "r" (see
figure 32), and attach the ground wire to the
terminal across from the green wire tagged
with the ground symbol. Make sure the termi-
nal screws are firmly tightened so the wires
will not pull out.